Toshiba Bar Code Printer - Repair of Installation Setting

16
4. The [Select Features] screen appears. The currently
installed features are marked with a check mark.
Remove the check mark for the features you want to
uninstall.
Check the features you want to install.
Click [Next] to start the modification.
 Removing all check marks and clicking [Next] display the
right screen.
Click [OK] to return to the [Select Features] screen.
 To remove all features, uninstall the Product referring to the
section, ‘Uninstallation of the Product‘.
5. The screen which shows a progress bar appears.
Clicking [Cancel] stops the operation.
6. The [Maintenance Complete] screen appears.
Click [Finish] to complete the operation.
Repair of Installation Setting
This reinstalls all features by the previous setup.
1. Click: [Start] – [All Programs] – [TOSHIBA TEC] – [UnInstall TEC Barcode Network Tool].
2. The [InstallShield Wizard] preparation message
appears.
 It may take a while until a next screen appears.