47
Printer Setting (TEC Barcode Net Config)
This feature is for changing the printer setting using the [Printer Setting] function. When configuring the system
of several printers at the same time, use [Batch Printer Set].
Important Notice on This Feature
This feature was designed based on the assumption that it is used by the Administrator. If there is a possibility
that the User may operate a computer on which the Product is installed, let the User enter the password on the
[Login] screen at the startup of the Surveillance Tool. To do this, check [Use password to log in] on the
[Management Options] screen of the Surveillance Tool. The Administrator must control this login password.
For details of the setting, please refer to the key operation sections of the System Mode Manual for each of the
Supported Printers.
TOSHIBA TEC shall not be liable for any outcome resulted from the use of this feature by the User.
Operation Flow
Starting Printer Setting
1. Start the Surveillance Tool and right-click the
applicable printer. Select [Printer Setting...].
When you logged in in User mode, you cannot select [Printer
Setting…].
You can also start [Printer Setting…] by Selecting [Device] –
[Printer Setting...].
Supplemental explanation:
[Batch Printer Set] is useful when configuring several
printers at the same time.
To select [Batch Printer Set], left-click and move the mouse
with holding down the left button over the applicable
printers. The selected printers will be highlighted.
Then, right-click and select [Printer Setting...].
Or, select [Device] – [Printer Setting...].
Note: [Batch Printer Set] is not available under the following
situation.
Selected printers are not the same model.
To Next Page
Loading...
Need help?
General
