17
3. The [Welcome] screen appears.
Check [Repair], then click [Next].
When changing the installation setting, check [Modify].
When reinstalling all features by the previous setup, check
[Repair].
When uninstalling all installed features, check [Remove].
4. The screen which shows a progress bar appears.
Clicking [Cancel] stops the operation.
5. The [Maintenance Complete] screen appears.
Click [Finish] to complete the operation.
Uninstallation of the Product
This feature completely removes the Product from your computer.
Note: You may not be able to uninstall the Product by clicking:
[Control Panel] – [Add or Remove Programs].
In such case, follow the uninstallation procedure described below:
1. Click: [Start] – [All Programs] – [TOSHIBA TEC] – [UnInstall TEC Barcode Network Tool].
2. The [InstallShield Wizard] preparation message
appears.
It may take a while until a next screen appears.
To Next Page
Loading...
