33
Search Options (Effective only in Administrator mode)
Selects a method for searching printers.
[Start the auto-search when TECNet Admin opens.]
Displays the [Search] screen at the startup of the Product
and automatically searches printers.
[Broadcast Search]
Searches printers by Broadcast Search and adds
SNMP-compliant printers to the Printer List.
Note: Printers may not be searched depending on network
environment. When broadcast is blocked by a router, a
search is performed within the same segment.
Perform a search by [Specification Search] or by specifying
an IP address.
‘By Specifying IP Address’
[Specification Search]
Searches SNMP-compliant printers under specified conditions and adds them to the Printer List.
[Start IP]
Enabled when [Specification Search] is selected. Specifies a start IP address of a search range.
First to fourth segment of IP address: 0 to 255
Do not specify 0 as an effective host address. 255 in the fourth segment defines multicast. The IP
address must be specified in a way so that the combination of the IP address and the subnet mask,
set in printer System mode, must be valid. Even when a wrong IP address is specified, a printer can
be added, but you cannot access the printer.
[End IP]
Enabled when a start IP is entered, but disabled if the fourth segment of the start IP address is 255.
Only the fourth segment of an end IP address of the search range is entered. (0 to 255)
[Add]
Enabled when a search range is entered. Otherwise, disabled.
Adds the search range in the search condition list. (Up to 10)
[Remove]
Enabled when a search condition list is selected. Otherwise, disabled.
Removes the conditions selected on the search condition list.
Disabled when the search condition list is not selected.
[Search for all SNMP-compliant printers]
Displays printers other than the Supported Printers.
[Search Time]
Sets a time for searching printers 1 second to 600 seconds.
[Import]
Retrieves setting information from a file.
[Export]
Saves setting information to a file.
[OK]
Exits with enabling all settings.
[Cancel]
Exits without saving the current setting.
To Next Page
Loading...
Need help?
General
