56
Strip position fine adjustment
Assuming the label gap is 2 mm, the print stop position in
strip issue mode is designed in a manner so that printing
stops when the distance from the middle of the gap
between labels to the end of the strip shaft is 4 mm.
When this print stop position is not proper because the gap
is more than 2 mm, the print stop position should be
adjusted using the strip position fine adjust function.
BACK ADJ. (Back feed fine adjustment)
There may be cases where a label is not returned to the
home position depending on the print conditions, even if a
backfeed length is the same as a forward feed length.
When an operation including back feed (cut issue, strip
issue, forward feed standby after an issue) is performed
using a sensor, a label/tag may not be returned to the home
position resulting an error, if the label pitch length is almost
the same as the distance between the thermal print head
and the paper sensor (69.8 mm). To prevent this problem,
the backfeed length should be increased by performing the
back feed fine adjustment in the + direction.
Print head
Platen
0.0 mm
+
To Next Page
Loading...
Need help?
General
