4 SCAN FUNCTIONS
114 Basic Scan Procedure
Basic Scan Procedure
This equipment supports scanning from TWAIN-compatible applications. TWAIN is the standard that links applications and
scanners that acquire images. For TWAIN support, see your application’s manual. Before you start scanning with this
equipment, make sure that you have installed the scanner driver.
P.41 “Preparation 4 - Installing Printer and Scanner Drivers”
The default original size depends on the measurement system on Windows: A4 for Metric or LT for U.S.. You can
change the default only before the first execution after installation. For the measurement system, see the Windows
Help.
Scanning images
Follow the steps below to scan the original.
1
Place the original face down.
1) Open the platen cover.
2) Place the original face down on the original glass.
3) Align the original against the left rear corner of the original glass.
Do not place heavy objects (4 kg/9 lb. or over) on the original glass and do not force it down.
Breaking the glass could injure you.
When you use a transparent original such as overhead transparencies and tracing paper, place a blank plain
sheet of paper - the same size or larger - over the original.
2
Run your TWAIN-compatible application and execute the image acquisition command
from within the application.
You usually execute the scan or image acquisition command on the File menu to select this equipment. The
location of the image acquisition command and the method to select the scanner vary according to the application.
See your application’s manual.
To Next Page
Loading...
