1 PREPARATION
Preparation 1 - Turning Power ON 27
Preparation 1 - Turning Power ON
Turning power ON
1
Press the power switch to “ ” (ON) side.
The equipment starts warming itself up. The warm-up time takes approx. 25 seconds. When the warm-up has
finished, the Alert lamp is turned off and the equipment is ready for copying.
If you press the [START] button with an original placed while the warm-up is still continuing, copying
automatically starts after it has finished. This is called auto job start. When the job is reserved, “WARMING UP”
appears on the LCD screen to show you the current status.
However, this function cannot be accessed while “Please wait” is being displayed (approx. 15 seconds).
Turning power OFF
Press the power switch to “ ” (OFF) side.
Saving energy when not in use - Energy saving mode -
To reduce power consumption, the equipment automatically enters into the energy saving mode when a specified period
of time has passed since its last use. You can also switch the equipment into this mode manually.
Types of energy saving mode
There are two types of the energy saving mode as follows.
Low power mode: “SAVING ENERGY” appears on the LCD screen.
Sleep mode: The LCD screen disappears and only the Alert lamp is lit.
The timers for “AUTO LOW POWER” and “AUTO SLEEP” have been set respectively to 5 minutes and 1 minute as the
factory default settings. You can change them in the “MENU” mode.
P.130 “Setting the timers for auto clearance and energy-saving”
To turn the equipment into the Energy saving mode manually
You can operate in the “MENU” mode to make the equipment sleep manually. For the operation, see the page below.
P.135 “Entering the sleep mode”
Canceling conditions for energy saving mode
The energy saving mode is canceled under the following conditions. After the warm-up has been completed, the
equipment goes into the ready status.
1
READY
DRAWER:A4-R
AUTO
100%
TEXT/PHOTO
To Next Page
Loading...
