7.MAINTENANCE AND INSPECTION
Regular Cleaning 159
7 MAINTENANCE AND INSPECTION
2
Clean the charger.
Hold the cleaning knob of the charger and pull it out toward you carefully until it comes to a stop. Then reinsert it in
its original position carefully. Repeat this procedure two or three times.
Check if the cleaning knob is fully inserted after cleaning.
3
Close the front cover.
Cleaning transfer charger
When the transfer charger wire is dirty, white steaks or unevenness of the density may appear on copied images, or the
density of the whole image may be lowered. Clean the transfer charger wire as follows.
Be careful not to let your fingers be caught between the equipment and the side cover.
This could injure you.
1
Open the side cover.
2
Pull the transfer unit toward you carefully to lay it down while holding up the green
lever.
To Next Page
Loading...
