Toshiba E-studio18 - Left Side;Inner Side

1.PREPARATION
Description of Each Component 23
1 PREPARATION
 Left side/Inner side
1. Original glass
Use this to copy or scan three-dimensional originals, book-type originals and special paper such as overhead
transparencies or tracing paper, as well as plain paper.
2. Control panel
Use this to perform copying, key in the copy quantity, or set other functions.
 P.24 “Control panel”
3. Toner cartridge
 P.13 “Recommended toner cartridges”
 P.146 “Replacing Toner Cartridge”
4. Exit support tray
This tray aligns the printed paper.
 P.152 “Installation and Removal of the Exit Support Tray”
5. Power switch
Turn the power of the equipment ON or OFF with this.
 P.27 “Preparation 1 - Turning Power ON”
6. AC-IN terminal
Use this to connect the co-packed power cable and the equipment.
7. USB terminal (4-pin)
With this terminal, the equipment can be connected to your PC using a commercially available USB cable.
y Use a USB2.0 Hi-Speed certified cable: USB cable supporting the USB2.0 Hi-Speed mode (480 Mbps of
transfer speed) certified by the USB Implementers Forum.
y Connect the equipment with a PC directly by the USB cable. When it is connected with a PC via a USB hub, the
equipment may not be recognized.
8. Receiving tray
9. Original scale
Use this to check the size of an original placed on the original glass.
10. Platen sheet
 P.158 “Regular Cleaning”
6
7
8
9
10
5 4
1
2
3