6 TROUBLESHOOTING
150 Replacing Toner Cartridge
7
Clean the charger.
Hold the cleaning knob of the charger and pull it out toward you carefully until it comes to a stop. Then reinsert it in
its original position carefully. Repeat this procedure two or three times.
Check if the cleaning knob is fully inserted after cleaning.
After the toner cartridge has been replaced, be sure to clean the transfer charger wire following the procedure
below in order to prevent uneven image density.
8
Open the side cover.
9
Pull the transfer unit toward you carefully to lay it down while holding up the green
lever.
10
Remove the transfer charger cleaner from the front pocket of the transfer unit.
To Next Page
Loading...
