Toshiba E-STUDIO2006 - Page 138

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 18
4.3.3 CIS case
(1) Take off the CIS unit.
 P. 4-15 "4.3.2 Contact Image Sensor unit
(CIS)"
(2) Remove the tension spring [1].
Fig. 4-44
(3) Take off 1 pulley [2] and CIS case [3].
Notes:
1. When replacing the pulley, apply
Molykote (EM-30L) between the
tensioner and pulley shaft.
2. If the spring comes off, it is attached black
spring [5] to the front side, and brown
spring [6] to the rear side.
Fig. 4-45
(4) Remove the CIS unit drive belt [4].
Fig. 4-46
[
1
]
[
2
]
[
3
]
[
5
]
[
6
]
[4]