Toshiba E-STUDIO2006 - Description of Operation

3
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
OUTLINE OF THE MACHINE
3 - 37
3.8.4 Description of Operation
[ 1 ] Scanning operation
• Scanning an original on the original glass
During the scanning operation, the rotation of the scan motor (M1) is transmitted to the timing belt to
move the CIS unit (CIS).
The CIS unit (CIS) makes the position of the shading correction plate, attached to the inside of the
top cover, move left-to-right to carry out the initialization.
At this time, the CIS unit (CIS) detects the black mark position on the shading correction plate and
thus the home position is determined.
When the [START] button is pressed, the CIS unit (CIS) starts scanning the originals.
When scanning is finished, the CIS unit (CIS) carries out the initialization, returns to its home
position and then stops.
• Scanning an original on the RADF
When originals are scanned from the RADF, the CIS unit (CIS) moves to the position of the RADF
original glass and then stops.
The originals transferred from the RADF are scanned while they pass through the upper surface of
the RADF original glass where the CIS unit (CIS) has stopped.