Toshiba E-STUDIO2006 - Exit Roller

4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 113
4.9.12 Exit roller
Notes:
1. Be sure to install the thermistors so that
their bosses are securely inserted into the
frames.
Notes:
After the thermistors are installed in the fuser
unit, check that their gauge heads (indicated
by the red arrow) contact the fuser roller. If
there are gaps between them or the
thermistors are tilted, reinstall them.
[1] Center/Side thermistor
[2] Edge thermistor
Fig. 4-301
Fig. 4-302
(1) Take off the tray rear cover.
 P. 4-4 "4.1.8 Tray rear cover"
(2) Remove 1 clip [1] and take off 1 bushing [2].
Fig. 4-303
[2][1]
[1]
[2]