e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 26
8.3.4 Paper misfeeding
[E110] ADU misfeeding
Classification Error content
Paper misfeeding Jam not reaching the registration sensor)
Proce
dure
Check item Result Measure
Next
Step
1
Open the ADU. Is there
any paper in front of the
registration sensor?
Yes Remove the paper.
No
2
2
Is the registration sensor
working?
(Perform the input check
in the test mode: 03-[A]/
[A])
Yes
3
No • Check if the connector of the registration
sensor is disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN22
23LA/23LM/28LM/23HA/28HA: CN14
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the 1st registration sensor.
• Replace the MAIN board.
3
Is the ADU clutch
working? (Perform the
output check in the test
mode: 03-222)
Yes
4
No • Check if the connector of the ADU clutch is
disconnected.
• Check if the connector CN17 on the MAIN
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the ADU clutch.
• Replace the MAIN board.
4
Rollers in the ADU • Check the rollers in the ADU. Replace them
if they are worn out.
Parts to be replaced Remark
ADU clutch
MAIN board
Rollers in the ADU
To Next Page
Loading...
