e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 70
8.4.4 Toner offset
Fig.8-6
Toner offset (Shadow image appears approx.72mm toward the dark image.)
Defective area Step Check items Prescription
Density 1 Is the density too high? Adjust the density.
Fuser unit 2 Is the pressure of the fuser roller
normal?
Check the pressure releasing parts and
pressurization mechanism.
3 Is the thermistor in contact with the fuser
roller?
Contact the thermistor with the fuser
roller.
4 Is there a scratch on the fuser roller
surface?
Replace the fuser roller.
5 Has the fuser roller reached its PM life? Replace the fuser roller.
6 Is the setting temperature of the fuser
roller normal?
Check the adjustment values of fuser
roller temperature?
08-2010, 2009, 2100
7 Is the power supplied between the fuser
unit entrance guide and the registration
roller on the equipment side?
Check if the power supply bracket of the
fuser unit is installed properly.
Paper 8 Has the appropriate paper type been
selected?
Select a proper mode.
9 Is the setting temperature of the fuser
roller in each paper type normal?
Check the setting and correct it.
(08-2049, 2050, 2051, 2194)
10 Using the recommended paper? Use the recommended paper.
Developer material 11 Using the specified developer material? Use the specified developer material and
toner.
Scanner 12 Are the original glass (especially the
position of shading correction plate) and
CIS unit dirty?
Clean them.
Feeding direction
Approx.72mm
To Next Page
Loading...
