Toshiba E-STUDIO2006 - Other Jam

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 38
8.3.6 Other jam
[E030] Paper remaining inside the equipment at power-ON
Relation between the jamming area and the corresponding sensors and covers
(If a jam is occurring in the PFU check the board in each unit.)
Classification Error content
Other jam Power-ON jam
Proce
dure
Check item Result Measure
Next
Step
1
Open the cover of the unit/
area whose picture is
blinking on the control
panel. Is there any paper
on the transport path?
(Refer to the following
table.)
Yes Remove the paper.
No
2
2
Is the sensor in the
jamming area working?
(Perform the input check
in the test mode: refer to
the following table.)
Yes
3
No • Check if the connector of the sensor is
disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the sensor
3
MAIN board • Replace the MAIN board.
Parts to be replaced Remark
Sensor Refer to the following table
MAIN board
Jamming area Cover Sensor Test mode / Input check
Registration area Right cover Registration sensor 03-[A]/[A]
Exit area Right cover Exit sensor 03-[A]/[B]
ADU Right cover ADU paper path sensor 03-[1]/[C]
PFU PFU side cover PFU drawer feed sensor 03-[4]/[A]
PFP PFP side cover PFP upper drawer feed sensor 03-[1]/[E]
PFP upper lower feed sensor 03-[2]/[C]