6
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SETTING / ADJUSTMENT
6 - 35
6.6.5 Fine adjustment of black density
The density of black side on scanned image is adjusted at color-scanning.
<Adjustment Mode (05)>
Notes:
Be careful for the value not to be too large since the gradation is reproduced worse in darker
side.
<Procedure>
The procedure is the same as that of  P. 6-24 "6.4.2 Density adjustment".
6.6.6 RGB conversion method selection
The color space conversion method of image is decided at color-scanning.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of  P. 6-24 "6.4.2 Density adjustment".
6.6.7 Adjustment of saturation
The saturation of the scanned image is adjusted for color-scanning.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of  P. 6-24 "6.4.2 Density adjustment".
Code Original mode Remarks
8314 Text / Photo The larger the value is, the black side of the image becomes darker.
Acceptable values: 0 to 4
Default:
8314:1
other: 0
8315 Text
8316 Photo
Code Original mode Remarks
8319 Text /Photo 0: sRGB, 1: AppleRGB, 2: ROMMRGB, 3: AdobeRGB
(Default: 0)
8320 Text
8321 Photo
Code Original mode Remarks
8324 Text / Photo The larger the value is, the brighter the image becomes.
The smaller the value is, the duller the image becomes.
Acceptable values: 0 to 255 (Default: 128)
8325 Text
8326 Photo
To Next Page
Loading...
Need help?
General
