4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 87
4.8.9 Fuser center thermostat (THMO1) / Fuser front thermostat
(THMO2)
(1) Take off the base unit.
P. 4-82 "4.8.5 Base unit"
(2) Remove 2 screws and then take off the fuser
thermostat [1].
Fig. 4-231
Notes:
1. When attaching the fuser thermostat,
place the round terminal of the cable
above the thermostat terminal, and attach
in the direction shown in the figure.
Fig. 4-232
Notes:
1. Make sure that the terminal of the
thermostat harness does not contact the
metal plate.
Fig. 4-233
[1]
To Next Page
Loading...
