8
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
8 - 69
8.4.3 Moire/lack of sharpness
Fig.8-5
Moire
Lack of sharpness
Defective area Step Check items Prescription
Density reproduction 1 Check the reproduction of the image
density.
Adjust the density.
Parameter adjustment
value
2 Check the image processing
parameters.
Check the adjustment value for
sharpness.
Printer section 3 Check test print image (04-114). When defects occur, perform the
corresponding troubleshooting
procedure.
Defective area Step Check items Prescription
Density reproduction 1 Check the reproduction of the image
density.
Adjust the density.
Parameter adjustment
value
2 Check the image processing
parameters.
Check the adjustment value for
sharpness.
Printer section 3 Check test print image (04-114). When defects occur, perform the
corresponding troubleshooting
procedure.
4 Check the image processing
parameters.
Check the encircled areas A and B in
the image, and change the
sharpness intensity in the sharpness
adjustment mode.
Feeding direction
AB
To Next Page
Loading...
