Toshiba E-STUDIO2006 - Separation Finger

4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 107
4.9.8 Separation finger
(5) Release 2 bushings [4], and take off the
pressure roller [5].
Fig. 4-284
(1) Take off the base unit.
 P. 4-105 "4.9.6 Base unit"
(2) Remove each 1 spring [1].
Fig. 4-285
(3) Take off 5 separation fingers in the following
order.
[1] Lift the separation finger upward, and
then slide it forward.
[2] Slide the separation finger to the front
side, and then rotate it in a twisted manner.
[3] Remove the separation finger from the
groove.
Fig. 4-286
[5]
[4]
[4]
[1]
[1]
[2] [3]