e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 2
7.2 PM Support Mode (6S)
7.2.1 General description
The timing for the parts replacement usually depends on the number of output pages ever printed after
they were replaced before. However, the life span of them changes depending on the general use of
users and the environment in which the equipment is placed. Therefore, it is necessary to consider not
only the number of output pages but also the drive counts when deciding the timing for the parts
replacement in order to utilize the parts and materials effectively.
This equipment has a PM support mode, which displays information on the state of use (number of
pages printed, drive time) of each replacement part, and enables the counter to be cleared more
efficiently during replacement.
The replacement record can be printed out in the list printing mode (9S-103).
7.2.2 Operational flow and operational screen
[ 1 ] Operational flow
<20H/23H/25H>
Fig. 7-1
[CANCEL] pressed
[ ] pressed
[2]
[START]
[1] [START]
Adjustment finished
Adjustment
finished
Main unit chosen
[ ] pressed
Sub unit chosen
[ ] pressed
PM support mode activated
[6] + [START] + [POWER] ON
Main Unit screen
Main unit list displayed
Sub Unit screen
Sub unit list displayed
Item chosen
[ ] pressed
Counter Item screen
Counter item
displayed.
Counter value screen
Counter value
displayed.
Code input screen
Code input screen
displayed.
Auto-toner automatic
adjustment perfomed
Automatic gamma
adjustment perfomed
[ ] pressed
[ ] pressed
To Next Page
Loading...
