Toshiba E-STUDIO2006 - Confirmation of the Updated Data

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
11 - 16
11.5 Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
The installed ROM versions can be confirmed in the list print mode following the procedure below.
Notes:
Since the fax ROM for the 23HA/28HA models is included in the system ROM, there is no fax
specific firmware or data file.
(1) Turn the power ON using the main power switch while pressing the digital key [9] and the
[START] button simultaneously.
(2) Select “Enter the code” using the arrow button.
(3) After pressing the [OK] button, press the [1] button three times, and then press the [START]
button.
(4) “VERSION LIST” is printed out.
* It is recommended to keep this list for future reinstallation such as the replacement of the
Main board.
(5) Turn OFF the power.
Firmware Check Method Remarks
BIOS firmware [OK]+POWER BIOS firmware version
System ROM
(System firmware)
08-9900 System ROM version
Updating Engine ROM
(Engine firmware)
08-9901 Engine ROM version
FAX ROM
(FAX firmware)
08-9905 FAX ROM version <20H/23H/25H only>