4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 79
2. When installing the entrance guide, make
sure that the part of the entrance guide
shown in the figure is outside the fuser
unit cover.
Fig. 4-207
3. Use the screw hole shown in the figure to
attach the entrance guide.
Fig. 4-208
(4) Place the fuser unit facing the original
direction, and remove the 2 screws.
Fig. 4-209
(5) Release 2 fuser unit latches and then take off
the fuser unit cover/fuser unit guide [3].
Fig. 4-210
[3]
To Next Page
Loading...
