e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 90
Notes:
1. Be sure to install the thermistors so that
their bosses are securely inserted into the
frames.
Notes:
Look at the thermistors in the direction of the
blue arrow after they are installed in the fuser
unit, and check that their gauge heads
(indicated by the red arrow) contact the fuser
roller. If there are gaps between them or the
thermistors are tilted, reinstall them.
[1] Center/Side thermistor
[2] Edge thermistor
Fig. 4-239
Fig. 4-240
[1]
[2]
To Next Page
Loading...
