8
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
8 - 31
[E160] PFP lower drawer misfeeding (paper not reaching the PFP lower drawer feed sensor)
MAIN board
PFP upper drawer feed clutch
PFP upper drawer feed roller
Separation roller
Pickup roller
Classification Error content
Paper misfeeding Jam not reaching the PFP lower drawer feed sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the PFP side cover.
Is there any paper in front
of the PFP lower drawer
feed sensor?
Yes Remove the paper.
No
2
2
Is the PFP lower drawer
feed sensor working?
(Perform the input check
in the test mode: 03-[2]/
[C])
Yes
3
No • Check if the connector of the PFP lower
drawer feed sensor is disconnected.
• Check if either of the connectors CN410 on
the PFP board is disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN26
23LA/23LM/28LM/23HA/28HA: CN15
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the PFP
board and MAIN board are short circuited or
open circuited.
• Replace the PFP lower drawer feed sensor.
• Replace the PFP board.
• Replace the MAIN board.
Parts to be replaced Remark
To Next Page
Loading...
