e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
11 - 10
(6) Select the file you want to update.
(7) Click the [Update] button.
The update starts and a status bar appears on the operating panel of the equipment.
Notes:
From 1 to 2 minutes are required to update the system ROM, and about 3 minutes are required
for the engine ROM.
Fig.11-9
Notes:
The following messages appear if the program data is not transmitted correctly.
Fig.11-10
(8) When the program data transmission is completed, the message shown below appears.
Fig.11-11
(9) Turn OFF the power of the equipment.
Notes:
• It is not possible to update the system ROM and the engine ROM at the same time. Do the
updates separately.
(10) If you update the system ROM, initialize the updated data.
• Turn ON the power while [0] button and [8] button are pressed simultaneously.
• Key in “9030”, and then press the [START] button.
• Press the [OK] button.
(11) When the update is finished, remove the USB cable.
FIRMWARE UPDATE
FIRMWARE UPDATE OK
MACHINE POWER OFF/ON
To Next Page
Loading...
