e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 26
(B) Pick-up failure in bypass
(C) Misfeed in equipment
• During bypass feeding
Bypass feed clutch ON
Registration sensor is not turned ON in a fixed period of time
“Misfeed in bypass” is displayed: E120
Copying operation is disabled
Solution: Remove the paper from the bypass tray and open and close the right cover.
• Exit sensor detects jamming of the leading edge of paper.
Registration roller clutch ON
Fig. 3-24
Less than regulation time
Exit sensor ON
If the exit sensor is not turned ON after
regulation time
Paper jam (E010) The copying operation is
stopped.
• Exit sensor detects jamming of the tailing edge of paper.
Registration roller clutch OFF
Fig. 3-25
Less than regulation time
Exit sensor OFF
If the exit sensor is not turned OFF after
regulation time
Paper jam (E020) The copying operation is
stopped.
• Immediately after the power ON
Any of all sensors on paper transport path detects paper (ON)
Paper jam (E030)
Registration roller
clutch
Exit sensor
Timer
0
Paper jam (E010)
ON
ON
Regulation time
Registration roller
clutch
Exit sensor
Timer
0
Paper jam (E020)
ON
OFF
Regulation time
To Next Page
Loading...
