3
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
OUTLINE OF THE MACHINE
3 - 49
[B] Paper separation
This model separates the paper fed by the bypass feed roller using the bypass separation pad. The
bypass separation pad is pressed again the bypass feed roller by the spring. When more than two
sheets of paper are transported from the bypass feed roller, since the friction between the two sheets of
paper is smaller than between a sheet and bypass separation pad, only the uppermost paper is
transported by the bypass feed roller, and the paper below it are not transported due to the friction of
the bypass separation pad.
The paper transported by the bypass feed roller arrives at the registration roller. After it is aligned by the
registration roller, the bypass feed roller stops.
Fig. 3-47
[1] Bypass feed clutch
[2] Bypass separation pad
[3] Bypass feed roller
[4] Spring
[3]
[1]
[3]
[4]
[2]
To Next Page
Loading...
