Toshiba e-studio281c - Page 269

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
ADJUSTMENT
3 - 3
3
Note: Note:
The current sensor voltage (V) shown in (B) automatically changes, gradually approaching the
target value for adjustment reference voltage shown in (A).
• In 30 to 60 seconds, the current sensor voltage (V) in (B) is converged. Then the sensor out-
put control value (bit value) corresponding to the initial developer material is displayed in (C).
Note: Note:
Be careful that the values in (A), (B) and (C) vary with humidity.
• In case of single-color adjustment, press the [ENTER] button to store the adjustment results
in memory when the control value is displayed. In case of multiple-color adjustment, it is auto-
matically proceeded to the adjustment of next color.
(5) Adjustments for “Y”, “M” and “C” (light sensor control)
• In 15 to 45 seconds, the following message will be displayed (The time varies with the num-
ber of colors to be adjusted).
(
B
)
: Current sensor voltage
(
V
)
(
C
)
: Sensor output control value
(
bit value
)
(
A
)
: Target value
(
V
)
for adjustment reference voltage
K: xxxV
K: yyy
K: zzzV
(
B
)
(
C
)
(
A
)
(
B
)
(
C
)
(
A
)
(
B
)
: Current sensor voltage
(
V
)
(
C
)
: No display
(
A
)
: Target value
(
V
)
for adjustment reference voltage
Y:
Y: