e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 78
3.13 Adjustment of the Finisher (MJ-1022)
3.13.1 Adjusting the jogging plate width
(1) Remove the right inner cover and the rear cover.
(4) Measure the jogging width (standard at 317 mm).
(2) Adjust the front jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in Fig. 3-1301.
• Press SW2 twice on the finisher controller
PC board.
- The front jogging plate moves to the
home position.
Fig. 3-66
(3) Adjust the rear jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in Fig. 3-1302.
• Press SW2 twice on the finisher controller
PC board.
- The rear jogging plate moves to the
home position.
Fig. 3-67
Fig. 3-68
ON
12345678
ON
12345678
Rear jogging plate home position
To Next Page
Loading...
