e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 28
<Updating Finisher ROM (MJ-1101)>
(1) Attach the ROM to the download jig
Make sure that the ROM and its direction are correct.
P. 6-3 " K-PWA-DLM-320"
(2) Turn OFF the power of the equipment.
(3) Remove 1 screw and take off the board access cover.
Fig. 6-30
(4) Connect the download jig with the jig connector (CN9) on the Finisher control board.
Fig. 6-31
(5) Turn ON the power while pressing [0] and [8] simultaneously.
Updating starts and the LED on the download jig lights
Board access cover
Download jig
06/08
To Next Page
Loading...
