Toshiba e-studio281c - Thermistor; Separation Roller; Paper Holder Cam

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
PREVENTIVE MAINTENANCE (PM)
4 - 27
4
* m2. Thermistor
Clean the thermistor with alcohol if the toner or dirt is sticking to it when the fuser roller is
replaced. Do not deform or damage the thermistor during the cleaning. Replace the ther-
mistor with a new one if it is damaged or deformed regardless of degree.
* m3. Separation roller
When replacing the transfer belt, apply some White Molykote (HP-300) on both ends of
the separation roller shaft.
Fig. 4-26
* q1. Paper holder cam
Apply an adequate amount of white grease (Molykote EM-30L) all around the paper holder
cam.
Fig. 4-27
Paper holder cam
06/08