e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 2
[E020] Stop jam at the exit sensor
Open the jam access cover. Is there any paper on the transport path?
È YES Æ Remove the paper.
NO
Is the exit sensor working? (Perform the input check: 03-[FAX]OFF/[7]/[H])
|
|
|
|
|
|
|
|
|
È
NO Æ 1) Check if the connector of the exit sensor is disconnected.
2) Check if the connector CN334 on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the exit sensor.
6) Replace the LGC board.
YES
Check the exit roller. Replace it if it is worn out.
05/07
To Next Page
Loading...
