Toshiba e-studio281c - Punch Motor (M3) Home Position Detection Error; Punch ROM Checksum Error; Punch RAM Read;Write Error

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
TROUBLESHOOTING
5 - 79
5
[CC61] Punch motor (M3) home position detection error
[CC71] Punch ROM checksum error
[CC72] Punch RAM read/write error
* The [CC61] error will be displays when the [E9F0] error occurs three times in succession or
during the initial operation.
MJ-1101 (When MJ-6101 is installed)
Is there any paper remaining on the transport path?
È
ÆYES Remove the paper.
NO
Rotate the punch motor (M3). Does it rotate smoothly?
È
ÆNO Fix the mechanism.
YES
Are the punch home position sensor (S4) and its wiring correct?
È
ÆNO Replace the sensor. Correct the wiring.
YES
Is the wiring between the hole punch control PC board (HP) and punch motor (M3) correct?
È
ÆNO Correct the wiring.
YES
1) Replace the punch motor (M3).
2) Replace the hole punch control PC board (HP).
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short cir-
cuited?
È
ÆYES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short cir-
cuited?
È
ÆYES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
06/08