Toshiba e-studio281c - Rack Gear, Pinion Gear (Aligning Plate); Finishing Tray Shaft; Movable Tray Drive Gear

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
PREVENTIVE MAINTENANCE (PM)
4 - 29
4
* q4. Rack gear, pinion gear (Aligning plate)
* q5. Finishing tray shaft
1) Take off the metal shield plate.
* If the hole punch unit is installed, take it off beforehand.
2) Apply oil as follows through the opening which shows up when the metal shield plate
has been removed.
Apply an adequate amount of white grease (Molykote EM-30L) to the gear teeth of the
rack and pinion gears which drive the aligning plate, and the entire finishing tray shaft.
Fig. 4-30
* q6. Movable tray drive gear
Apply an adequate amount of white grease (Molykote EM-30L) to the gear teeth of the
gear-A and gear-B.
Fig. 4-31
Finishing tray shaft
Rack gear
Pinion gear
Gear A
Gear B
06/08