Toshiba e-studio281c - Rear Alignment Plate Home Position Error; Paddle Home Position Error

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 50
[ED14] Rear alignment plate home position error
[ED15] Paddle home position error
MJ-1101
Is there any mechanical problem when the rear alignment plate is moved?
È
ÆYES Fix the mechanism.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the rear align-
ment plate home position sensor (S8)?
l
l
È
ÆYES • Connect the connector securely.
• Reinstall the sensor correctly.
• Replace the sensor.
NO
Is the harness between the rear alignment plate home position sensor (S8) and the finisher
control PC board (CN11) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Is the harness between the rear alignment motor (M10) and the finisher control PC board
(CN10) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Replace the finisher control PC board.
MJ-1101
Is there any mechanical problem when the paddle is rotated?
È
ÆYES Fix the mechanism.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the paddle home
position sensor (S3)?
l
l
È
ÆYES • Connect the connector securely.
• Reinstall the sensor correctly.
• Replace the sensor.
NO
Is the harness between the paddle home position sensor (S3) and the finisher control PC
board (CN5) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Is the harness between the paddle motor (M8) and the finisher control PC board (CN6) discon-
nected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Replace the finisher control PC board.
06/08