e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 82
3.13.4 Adjusting the tension of the stack processing motor belt
(1) Remove the right inner cover and the rear cover.
(2) Remove the 2 mounting screws, and detach
the grip unit.
Fig. 3-75
(3) Loosen the screw on the tension arm plate.
(The tension arm plate will be pulled under
tension by the tension spring.)
Fig. 3-76
Screw
Grip unit
Screw
Screw Tension arm plate
To Next Page
Loading...
