Toshiba e-studio281c - Page 349

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
ADJUSTMENT
3 - 83
3
(4) Move the returning roller shaft to its lower
limit (the slack of a belt is lightly taken); then,
tighten the screw on the tension arm plate.
Fig. 3-77
(5) Check to make sure that the returning roller
shaft moves smoothly.
Fig. 3-78
Screw
Tension arm
plate
Returning
roller shaft
Returning
roller shaft