© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
TROUBLESHOOTING
5 - 51
5
[ED16] Buffer tray home position error
MJ-1101
Is there any mechanical problem when the buffer tray guide is opened/closed?
È
ÆYES Fix the mechanism.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the buffer tray
home position sensor (S5)?
l
l
È
ÆYES • Connect the connector securely.
• Reinstall the sensor correctly.
• Replace the sensor.
NO
Is the harness between the buffer tray home position sensor (S5) and the finisher control PC
board (CN18) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Is the harness between the buffer tray guide motor (M3) and the finisher control PC board
(CN18) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Replace the finisher control PC board.
06/08
To Next Page
Loading...
