e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 22
3.5.2 Color Deviation Adjustment
The color deviation amount of the secondary scanning direction can be adjusted as follows.
There are 2 methods to adjust color deviation; using "Test pattern 63 (for A3/LD size paper)" or "Test
pattern 68 (for A4/LT size paper)" (adjustment method 1), and using "Test pattern 64 (for A3/LD size
paper)" (adjustment method 2). Adjust using either one of these methods.
* Only adjustment method 1 can be used for A4/LT paper.
Note: Note:
Follow the procedure in the order below for the color deviation adjustment.
If you start in the middle of the procedure, continue the subsequent steps.
E.g.: If you start with step 2 (A3/LD, 2nd sheet), perform steps 3 to 6.
Adjustment
method
Type Printing Image
Paper size,
Number of pages
Procedures
1 Test pattern 63 (A3/LD) Ladder A3/LD, 2 pages 05-63-[FAX]
Test pattern 68 (A4/LT) Ladder A4/LT, 4 pages 05-68-[FAX]
2 Test pattern 64 (A3/LD) Block A3/LD, 2 pages 05-64-[FAX]
Order Test pattern
1 A3/LD, 1st page
2 A3/LD, 2nd page
3 A4/LT, 1st page
4 A4/LT, 2nd page
5 A4/LT, 3rd page
6 A4/LT, 4th page
To Next Page
Loading...
