Toshiba e-studio281c - 3.13.3 Adjusting the overlap of the sensor flag

To Next Page

To Previous Page

ADJUSTMENT

3 - 81

3.13.3 Adjusting the overlap of the sensor flag

If the overlap between the sensor and the flag is wrong for some reason, perform the following adjust-

ment.

(1) Remove the processing tray unit.

(2) Loosen the mounting screw of the front/rear

jogging plate adjusting plate; then, move the

adjusting plate to the left and the right.

Fig. 3-73

(3) Tighten the screw so that the overlap

between the flag of the front/rear jogging

rack plate and the sensor is 1.5 mm to 2.0

mm.

Fig. 3-74

Jogging plate

adjusting plate

Screw

Adjusting plate

Screw

Jogging plate

adjusting plate

Adjusting plate

Sensor Sensor flag

1.5 mm to 2.0 mm

Other manuals for Toshiba e-studio281c