e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 50
(2) Adjusting carriages-1 and -2 positions
• Move the carriage-2 toward the exit side.
• Loosen the screws fixing the front side pulley bracket, make the sections A and B of the car-
riage-2 touch with the inside of the exit side frame and screw them up.
Fig. 3-16
• Put the carriage-1 on the rail, make the sections C and D of it touch with the inside of the exit
frame and screw up the front/rear side of the bracket to fix it.
Note: Note:
Make sure that the sections A and B of the carriage-2 touch with the exit side frame.
Fig. 3-17
Carriage-2 Pulley bracket
Exit side frame
B A
[
Rear
] [
Front
]
Enlarged view of carriage
Carriage-1
Exit side frame
Bracket
Bracket
[
Rear
] [
Front
]
Enlarged view of carriage
D
C
To Next Page
Loading...
