e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 60
Notes:
1. When confirming and adjusting the gap between the developer sleeve and the doctor blade,
insert the gauges into the gap after rotating the developer sleeve so that its marking faces the
doctor blade.
2. While reattaching the color developer unit cover, set the latches securely.
(5) Insert the gauge “0.50” of the doctor-sleeve
jig into the gap between the developer
sleeve and doctor blade and make sure that
the gauge can move smoothly in the front/
rear direction. In addition, confirm that the
gauge “0.60” cannot be inserted into the gap.
Fig. 3-35
Developer sleeve
Doctor-sleeve jig
Doctor blade
To Next Page
Loading...
