e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 72
Duplex copying:
(1) Shift the aligning plate with the scale as the guide shown in the figure below to adjust the skew.
Fig. 3-56
(2) If the image skew is "C" as shown in the figure below, shift the aligning plate in the direction of "-
", and if "D", shift it to "+".
Fig. 3-57 Fig. 3-58
Shift the aligning plate in the direction of "-". Shift the aligning plate in the direction of "+".
C
D
To Next Page
Loading...
