e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 88
Note: Note:
Perform the shipping position operation when the finisher is packed again.
Lower stack tray
motor (down)
The lower stack tray moves down and
stops when the lower stack tray lower
limit sensor is turned ON.
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
Stapler motor The stapler motor stops after the stapling
operation.
• Press the stapler
safety switch
(S14).
• Turn OFF the joint
sensor (S4).
Shipping posi-
tion operation
The upper and lower stack trays move to
the shipping position and stop.
• Turn OFF the joint
sensor (S4).
Setting Item Operation To stop
ON
12345678
ON
12345678
ON
12345678
To Next Page
Loading...
