© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
TROUBLESHOOTING
5 - 17
5
[EB60] Paper remaining on the transport path due to multiple feeding
When the paper is fed from any of the lower drawer, PFP or LCF:
Open the jam access cover. Is there any paper in front of the upper drawer feed sensor?
È YES Æ Remove the paper.
NO
Are the upper/lower drawer feed sensors working?
(Perform the input check: 03-[FAX]ON/[3]/[H], /[3]/[G])
|
|
|
|
|
|
|
|
|
|
È
NO Æ 1) Check if the connectors of the upper/lower drawer feed sensors are discon-
nected.
2) Check if the connector CN338 on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the upper/lower drawer feed sensors.
6) Replace the LGC board.
YES
Check the rollers. Replace them if they are worn out.
Open the jam access cover. Is there any paper in front of the registration sensor?
È YES Æ Remove the paper.
NO
Is the registration sensor working? (Perform the input check: 03-[FAX]ON/[9]/[E])
|
|
|
|
|
|
|
|
|
È
NO Æ 1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN338 on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the registration sensor.
6) Replace the LGC board.
YES
Check the rollers. Replace them if they are worn out.
To Next Page
Loading...
