© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FIRMWARE UPDATING
6 - 5
6
(4) Connect the download jig with the jig connector (CN105, CN106) on the SYS board.
Fig. 6-4
(5) Turn ON the power while [8] button and [9] button are pressed simultaneously.
The screen for selecting the items to be updated is displayed. “*” is displayed next to the items to
be updated. (All items are selected in the default settings.)
When the FROM basic section software version to be updated is "V1.00 / 8.22" or earlier:
Fig. 6-5
Download jig number Connector name
Download jig 0 CN105
Download jig 1 CN106
Connector
Download jig 0
Download jig 1
06/08
To Next Page
Loading...
