e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 26
(4) Connect the download jig with the jig connector on the finisher control PC board.
Fig. 6-27
(5) Change the setting of the DIP switch on the finisher control PC board.
Change the setting of the DIP switch as follows according to the firmware to be updated.
Note: Note:
Record the current settings of the DIP switch before changing them. After the updating is com-
pleted, return the DIP switch to the status as record.
Fig. 6-28
<Updating Finisher Firmware>
Change all the setting of the DIP switch (1-8) to OFF.
<Updating Saddle Stitcher Firmware>
Change the setting of the DIP switch 1-6 to OFF and 7-8 to ON.
Connector
To Next Page
Loading...
