Toshiba e-studio281c - Page 589

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FIRMWARE UPDATING
6 - 31
6
(3) Remove 1 screw and take off the finisher board access cover.
Fig. 6-33
(4) Release the latches and take off the rear lower cover of the hole punch unit.
Fig. 6-34
(5) Remove 3 screws and take off the rear cover of the hole punch unit.
Fig. 6-35
Board access cover
Rear lower cover
Rear cover
06/08