Trane TR200 Series - Main Menu - FC Closed Loop - Group 20

Main Menu - FC Closed Loop - Group 20
20-** FC Closed Loop
This parameter group is used for configuring the closed loop PID Controller, that controls the output frequency
of the frequency converter.
20-0* Feedback
This parameter group is used to configure the feedback signal for the frequency converter’s closed loop PID
Controller. Whether the frequency converter is in Closed Loop Mode or Open Loop Mode, the feedback signals
can also be shown on the frequency converter’s display, be used to control a frequency converter analog output,
and be transmitted over various serial communication protocols.
Parameter Description
182 TR200 Programming Guide